Where Does One Begin?

keakap · Post by **keakap** » Wed Sep 09, 2009 9:17 pm

dusty wrote:... how much saw blade wobble I can accept, ...

Just struck me: if a wobble blade is perfectly all right to use to cut dado and groove, why not just consider the wobble in a regular blade as the "kerf width" adjustment?

charlese · Post by **charlese** » Wed Sep 09, 2009 9:28 pm

keakap wrote:Just struck me: if a wobble blade is perfectly all right to use to cut dado and groove, why not just consider the wobble in a regular blade as the "kerf width" adjustment?

Absolutely brilliant observation, keakap!!:D

Also would like to present an question to Dusty's .003" runnout. How much does that .003" effect your wood?

dusty · Post by **dusty** » Wed Sep 09, 2009 10:09 pm

charlese wrote: Also would like to present an answer to Dusty's .003" runnout. How much does that .003" effect your wood?

As I said in post #26. There is not enough wobble on this blade to be a problem (.003").