Looking for a part

ted2 · Post by **ted2** » Sat Feb 06, 2010 2:26 pm

Well, I am in the middle of restoring my dads old mark V; but there was a broken part, I think it's called the nylon coupling, the little plastic sheath that the quill feeds into. Can't find it on any schematics or on shopsmith's website. Any suggestions?

beeg · Post by **beeg** » Sat Feb 06, 2010 2:40 pm

Welcome to the forum ted2. Can ya post a pic of it?

JPG · Post by **JPG** » Sat Feb 06, 2010 3:04 pm

Item # 57

http://www.shopsmith.com/ownersite/partscat/headstockassemblyexpview.htm
http://www.shopsmith.com/ownersite/partscat/headstockassembly_1.htm

This part may vary depending upon which Mark 5/V you have. The splines in the quill shaft vary.

ted2 · Post by **ted2** » Sat Feb 06, 2010 3:46 pm

Well, I missplaced the part and the only view I have of it is in a sawdust video of rebuilding the quill. It's the nylon sheath that the quill slides into.
The part #57 mentiones doesn't seem to be the same as the broken piece. I exploded the diagram and can't see anything that would fit. Maybe if I had a better picture of the part I could tell.

ted2 · Post by **ted2** » Sat Feb 06, 2010 3:56 pm

Well, I missplaced the part and the only view I have of it is in a sawdust video of rebuilding the quill. It's the nylon sheath that the quill slides into.
The part #57 mentiones doesn't seem to be the same as the broken piece. I exploded the diagram and can't see anything that would fit. Maybe if I had a better picture of the part I could tell.

Ron309753 · Post by **Ron309753** » Sat Feb 06, 2010 4:22 pm

If it looks like this it's Item #57.

Sincerely,

Ron309753

JPG · Post by **JPG** » Sat Feb 06, 2010 6:01 pm

Ron309753 wrote:If it looks like this it's Item #57.

Sincerely,

Ron309753

That is what a 'broken' gilmer version looks like.

This is what a poly v version looks like.

[ATTACH]7805[/ATTACH]

ted2 · Post by **ted2** » Sat Feb 06, 2010 8:39 pm

Yep, that's it (the gilmer version) Thanks!

a1gutterman · Post by **a1gutterman** » Sat Feb 06, 2010 10:04 pm

ted2 wrote:Yep, that's it (the gilmer version) Thanks!

It does knot look like SS sells that part by itself. Maybe talking to customer service will help.

kd6vpe · Post by **kd6vpe** » Sun Feb 07, 2010 8:51 am

I would be interested in hearing if they sell it or not. I have thought mine had some wear at the end of the opeining causing my quill to spin freely when it was almost fully extended. Others had said that they dont wear out much so I did not pursue trying to order one.