SDSSmith wrote:Press???? You would be surprised what you can accomplish with some 2x4's and a hydraulic bottle jack.
[ATTACH]12860[/ATTACH] This has gotten a fair amount of use on motors and drive sleeves. I make hardwood accessories bored for the appropriate shaft size. So far so good.
Hmmm! Maybe THAT would separate my 'corroded er tailstock sleeve and center'! Still in cold storage!
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
That was a good idea regarding using threaded 3/8" threaded rod as extensions. I had some 1', 2' and 3' sections in my shop and just used the HF puller to reposition a set collar on an extra long shaft (not a SS piece of equipment). Thanks again:)
I (and others who rebuild) heat bearings on a 60 watt light bulb for about 10-15 minutes, makes them expand a few thousandths and installation is much easier. Nope, the heat wont hurt them as its lower than that generated while the bearings/motor's turning.
I have never had to heat any bearings for the SS but maybe sometimes they are tighter than what I have seen?
Michael Mayo
Senior IT Support Engineer
Soft Designs Inc. albiemanmike@gmail.com
1960's SS Mark VII, 1954 Greenie, 1983 Mark V, Jointer, Bandsaw, Jigsaw, Dewalt Slider, Delta Super 10, Delta 8" Grinder, Craftsman compressor, Drill Doctor, Kreg PH Jig, Bosch Jigsaw, Craftsman Router and Table...........and adding more all the time....
Still in cold storage!
