resaw jig for band saw

farley · Post by **farley** » Sat Aug 06, 2011 8:25 pm

After Jerry and I got together I decided to look into a resaw jig for the Band Saw. He was mentioning something about an adjustable one. Saw one up on youtube.

Have any of you made and adjustable (for thickness) jig? and did you use plans or just winged it?

TIA

JPG · Post by **JPG** » Sat Aug 06, 2011 8:40 pm

farley wrote:After Jerry and I got together I decided to look into a resaw jig for the Band Saw. He was mentioning something about an adjustable one. Saw one up on youtube.

Have any of you made and adjustable (for thickness) jig? and did you use plans or just winged it?

TIA

Attach it to the movable(adjustable) fence.(assuming Al table here).

charlese · Post by **charlese** » Sat Aug 06, 2011 9:31 pm

farley wrote:Have any of you made an adjustable (for thickness) jig? and did you use plans or just winged it? TIA

Yes. Just as adjustable as the bandsaw fence.

farley · Post by **farley** » Sat Aug 06, 2011 9:40 pm

I am talking about moving the "log" towards the blade on each pass, so as not to cut into any waste wood. Using a sled of sorts.

charlese · Post by **charlese** » Sat Aug 06, 2011 9:48 pm

Since you are sawing a log, it's best to slab off a small slice then use the fat from that slice against your fence jig.

Seems with a V type sled, you would be slicing off pieces of your sled. This way the sled would only work until the V is gone.

farley · Post by **farley** » Sat Aug 06, 2011 10:04 pm

thanks, I think I am over thinking this, have to play in the shop and see what I can do.

charlese · Post by **charlese** » Sat Aug 06, 2011 10:22 pm

Gonna change my mind - Probably would saw off a slab as said, then use that face to slide on the table, then saw another slab at right angles to the first. Then you would have both a reasonably flat surface on the table and another against the jig.

charlese · Post by **charlese** » Sat Aug 06, 2011 10:34 pm

Let's get back to a jig - Make an "L" shaped sled to hold the log. Then make a couple of metal dogs (like small cant hooks). These hooks will be placed on the top of the "L" and will hold the log from rolling when sawn.

The lower leg of the "L" must be shorter than the log's width. Now you can make several slices before sawing into the "L". Now rotate the log 90 degrees, re-hook and slice off some more. Repeat the rotation and slicing once or twice more. Now you have a relatively square piece. (there may be some wane remaining) From here you can just saw away as you would a board.

This would resemble a VERY SMALL sawmill/

peterm · Post by **peterm** » Sun Aug 07, 2011 6:52 am

Here is a picture of a commercial one for logs seen at a wood show:
[ATTACH]13901[/ATTACH]

pennview · Post by **pennview** » Sun Aug 07, 2011 10:22 am

Try a google search on "band saw sled resaw" and you'll find some useful examples.