Shopsmith Forums

Posted: **Sun Nov 10, 2013 4:26 pm**

anyone know the thread size/pitch for the bolt holding the 10E/ER pulley cover to the headstock? Anyone want to sell one for a couple bucks? Thanks!

Posted: **Sun Nov 10, 2013 4:45 pm**

enyoc wrote:anyone know the thread size/pitch for the bolt holding the 10E/ER pulley cover to the headstock? Anyone want to sell one for a couple bucks? Thanks!

They are cheaper at the hardware store.

3/8 - 16 x 1/2 square shoulder on the head. Cap screw with washer will work.

Posted: **Sun Nov 10, 2013 6:57 pm**

Thank you JPG!

Posted: **Thu Nov 21, 2013 9:05 am**

JPG: I couldn't find any 1/2" long 3/8x16 at the usual retail outlets, but the folks at Fastenal hooked me up. (posting this in case anyone is looking in the future)

https://forum.shopsmith.com/viewtopic.php?t=13634

Shopsmith Forums

10E pulley-cover bolt size?

10E pulley-cover bolt size?