Microjig Matchfit Dovetail Clamps

[mbcabinetmaker]

I recently bought these to retrofit to the front side of my bench.

1.jpg (463.97 KiB) Viewed 4897 times

When I built my bench I recessed T nuts and made the outside piece replaceable.

2.jpg (468.7 KiB) Viewed 4897 times

Unbolted and ready to go.

3.jpg (419.72 KiB) Viewed 4897 times

Dovetail bit installed and ready to route. This doesnt come with the clamps but they tell you that you need a 1/2" 14 degree dovetail bit.

4.jpg (366.08 KiB) Viewed 4897 times

I routed this very deeply and the result was a tight fit.

5.jpg (418.45 KiB) Viewed 4897 times

I had to do a little chisel work on the recessed bolt holds because I routed into them but I knew that going in.

[mbcabinetmaker]

6.jpg (469.38 KiB) Viewed 4895 times

A little past wax in the groove helped with the tightness.

8.jpg (380.58 KiB) Viewed 4895 times

This is going to be a huge benefit for clamping and sanding shelf edges.

9.jpg (404.69 KiB) Viewed 4895 times

I highly recommend these.

Next step is to make some sacrificial fences for the table saw.