Has anyone been able to adjust a Shopsmith Headstock to match the Power Station? I have found that I have to readjust each SPT when I move it from the Headstock to the Powerstation.
Thanks in advance for any suggestions!
Adusting Headstock to Match Power Station
Moderator: admin
If you have to adjust the horizontal alignment, I might try the set screw in the Mark V's headrest to align to the SPT. You might check out this thread: https://forum.shopsmith.com/viewtopic.php?t=5305Lodgepole wrote:Has anyone been able to adjust a Shopsmith Headstock to match the Power Station? I have found that I have to readjust each SPT when I move it from the Headstock to the Powerstation.
Thanks in advance for any suggestions!
Rob in San Diego
Email: SDSSmith51 AT gmail.com
Email: SDSSmith51 AT gmail.com
-
dusty
- Platinum Member
- Posts: 21530
- Joined: Wed Nov 22, 2006 6:52 am
- Location: Tucson (Wildcat Country), Arizona
Adjusting Headstock to Match Power Station
I think that I can freely move the bandsaw from the Power Station to the Crafter's Station to the Mark V without doing any adjustment.
Sorry that I am unable to verify that. The Doc says no lifting over 10 pounds for another two weeks.
Is your alignment problem horizontal or vertical? Do you have Shopsmith eccentric tubes?
Sorry that I am unable to verify that. The Doc says no lifting over 10 pounds for another two weeks.
Is your alignment problem horizontal or vertical? Do you have Shopsmith eccentric tubes?
"Making Sawdust Safely"
Dusty
Sent from my Dell XPS using Firefox.
Dusty
Sent from my Dell XPS using Firefox.