Shopsmith Forums

Algale, that would be fine with me, but how do I find the package I need??
$500 would be acceptable, is there a list of needed parts that is specific, as it's inevitable that maybes will result in problems !!

Thanks for any help!!

I have a Mark V 500 that has an old main table without Tee slots, it has just plain slots that can't accept the accessories that will lock down to the Tee slots! I know you can get an upgrade kit that comes with the main table, but I'm not looking to spend over $1000, when all I want is the new ...

That was one hell of a call!!

Wasn't sure about installing on the outside or inside edge of the gaurd, but installed on the outside edge, fit perfectly!

Thank you

Third photo
[ATTACH]26590[/ATTACH]

Second photo

[ATTACH]26589[/ATTACH]

Ive gotten the new washers PN 523093 to replace PN 50163.
Problem is they go so deep into the case that they are useless.
It seems that something is stopping the shaft from going all the way in.
The sleeve PN 501318 is set back from the outside edge of the case 0.28", as well as the retaining ring ...

Probably from the 70's

This part is not on the parts list or diagram!

My 16 year old decided to surprise me by disassembling our shopsmith bandsaw cleaning, painting the case, and reassembling!! Obviously I can't get too pissed, he meant well, however after reassembling the entire unit, I have a left over part it is a thin brass piece that's dimensions are 2.6" x 0.75 ...

I just needed to go back to my motor notes from 1985, dah!
Now that I figured out how to reverse the direction, is it safe to do with this my Greenie?

Thank you