They are back in the machine, so I cannot measure, but I agree 10mm is awfully short. I will order and give it a try. Thanks for the help.
- Aaron
Search found 4 matches
- Fri Feb 25, 2022 8:51 am
- Forum: Maintenance and Repair
- Topic: PowerPro Motor Mounting Bolts
- Replies: 3
- Views: 373
- Thu Feb 24, 2022 4:30 pm
- Forum: Maintenance and Repair
- Topic: PowerPro Motor Mounting Bolts
- Replies: 3
- Views: 373
PowerPro Motor Mounting Bolts
Hello,
When reinstalling the PowerPro motor I noticed there are 6 locations for bolts, but I only have 4 bolts. I would like to order the remaining two bolts from Shopsmith, but do not know how to find them. They are part number 50 in the schematic included and I have a picture of one at the tip of ...
When reinstalling the PowerPro motor I noticed there are 6 locations for bolts, but I only have 4 bolts. I would like to order the remaining two bolts from Shopsmith, but do not know how to find them. They are part number 50 in the schematic included and I have a picture of one at the tip of ...
- Wed Feb 09, 2022 8:49 am
- Forum: Maintenance and Repair
- Topic: Power cord inside headstock
- Replies: 6
- Views: 663
Re: Power cord inside headstock
Thanks for your comments. Found a picture on YouTube that helps too. Quite a journey ... these Shopsmiths. I will inspect the wires as suggested.
- Tue Feb 08, 2022 6:16 pm
- Forum: Maintenance and Repair
- Topic: Power cord inside headstock
- Replies: 6
- Views: 663
Power cord inside headstock
- IMG_0254.jpeg (385.89 KiB) Viewed 663 times
I am replacing the quill feed mechanism and noticed that the power line was running over the feed assembly which seems to put some stress on the line. Is this the normal path for the line or can it be below the quill feed?
Thanks