520 table setting jig

onevw · Post by **onevw** » Wed Oct 03, 2012 10:01 am

Anybody have and willing to sell the setting jigs that came with the 520 upgrade ?
The mark5 I bought came with the upgraded 520 table system with magnetic strip and I need to aline the system.
RICK
I know I can get them from Shopsmith but somebody may have a set they do not need anymore.

dusty · Post by **dusty** » Wed Oct 03, 2012 10:12 am

onevw wrote:Anybody have and willing to sell the setting jigs that came with the 520 upgrade ?
The mark5 I bought came with the upgraded 520 table system with magnetic strip and I need to aline the system.
RICK
I know I can get them from Shopsmith but somebody may have a set they do not need anymore.

They really are not a necessity. The objective, when using them, is to get all rails set at the same position relative to the top of the table. Any spacer that does that works as well as does the official gauge. My gauge sets the rail .406" below the table surface. Remember, the dimension is not critical. It is, however, important that the rail displacements at all points be the same dimension.

SDSSmith · Post by **SDSSmith** » Wed Oct 03, 2012 12:41 pm

onevw wrote:Anybody have and willing to sell the setting jigs that came with the 520 upgrade ?
The mark5 I bought came with the upgraded 520 table system with magnetic strip and I need to aline the system.
RICK
I know I can get them from Shopsmith but somebody may have a set they do not need anymore.

I have an extra if you would like to contact me off list.