IPM-1 Jointech

dgreen810 · Post by **dgreen810** » Fri Mar 07, 2014 11:35 am

Does anyone on this forum use the IPM-1 by Jointech fence for your table saw fence on a MK 5. If so what is your opinion? I have been using mine as a router fence, even used it with my drill press and radial arm saw.

I have the old original Incra Jig I use as well on occasion on my free standing drill press.

Don G

Gene Howe · Post by **Gene Howe** » Sat Mar 08, 2014 2:35 pm

Don't know if it's an I-PM. Mine's the one they built for the Shopsmith MKV.
I use it as the TS fence and router fence. It's a great piece of equipment.
Once the rails were attached, no other fence will work. And, without those rails, it can't be used any where else.

dgreen810 · Post by **dgreen810** » Sat Mar 08, 2014 3:43 pm

If you go to my site at http://www.picturetrail.com/smoke810 and look at the Tormek album, the picture showing all the carving knives, they are on the router table with the IPM-1 (Incremental positioning machine) on the right of the router insert.

edit: I just moved two more photos in the same album at the bottom of the list,

Don G

Gene Howe · Post by **Gene Howe** » Sat Mar 08, 2014 4:49 pm

Don,
Here's a picture of what I have. Except mine is a 500.
Not the same as yours. Sorry.

[ATTACH]24279[/ATTACH]

ecom1 · Post by **ecom1** » Fri Jan 13, 2017 3:05 pm

dgreen810 wrote:Does anyone on this forum use the IPM-1 by Jointech fence for your table saw fence on a MK 5. If so what is your opinion? I have been using mine as a router fence, even used it with my drill press and radial arm saw.

I have the old original Incra Jig I use as well on occasion on my free standing drill press.

Don G

Hey Don, I just PM'd you regarding this thread.

Shopsmith Forums

IPM-1 Jointech

IPM-1 Jointech

Re: IPM-1 Jointech