Speed Control Mounting Screws
Moderator: admin
Re: Speed Control Mounting Screws
Interesting idea. I've not tried these before. Thanks BuckeyeDennis for the feedback.
Re: Speed Control Mounting Screws
This is the solution that a seller on eBay ( simon*e ) utilized. If I remember correctly he called it an improved headstock.
- Attachments
-
- improved headstock.jpg (120.09 KiB) Viewed 5340 times
Re: Speed Control Mounting Screws
I just dealt with a similar issue when disassembling my headstock for restoration and lubrication. In my case the metal corner actually broke off completely and had to be epoxied back on. I can personally vouch for the effectiveness of a simple washer/nut combo behind the housing to hold the bolt in place. It works like a champ!
"Like a bull chasing the matador is the man left to his own schemes
Everybody needs someone beside em' shining like a lighthouse from the sea" - Brother, NEEDTOBREATHE
Everybody needs someone beside em' shining like a lighthouse from the sea" - Brother, NEEDTOBREATHE
-
chapmanruss
- Platinum Member
- Posts: 4544
- Joined: Tue Aug 26, 2014 8:16 pm
- Location: near Portland, Oregon
Re: Speed Control Mounting Screws
Since it is an "A" Headstock I would simply use a lock washer and nut on the back side to remount the Speed Control. It requires the motor to be removed but that will be needed to put the Headstock back together anyway. Using Simon's "improvement" you risk damaging the structure around the holes because it requires installing the blind nuts. Remember the Headstock is a soft metal casting.
Russ
Mark V completely upgraded to Mark 7
Mark V 520
All SPT's, 2 Power Stations & Crafter's Station
Model 10ER S/N R64000 first one I restored on bench w/ metal ends & retractable casters.
Has Speed Changer, 4E Jointer, Jig Saw with lamp, a complete set of original accessories & much more.
Model 10E's S/N's 1076 & 1077 oldest ones I have restored. Mark 2 S/N 85959 restored.
Mark V completely upgraded to Mark 7
Mark V 520
All SPT's, 2 Power Stations & Crafter's Station
Model 10ER S/N R64000 first one I restored on bench w/ metal ends & retractable casters.
Has Speed Changer, 4E Jointer, Jig Saw with lamp, a complete set of original accessories & much more.
Model 10E's S/N's 1076 & 1077 oldest ones I have restored. Mark 2 S/N 85959 restored.
Re: Speed Control Mounting Screws
I had a similar problem occur with my Mark V model 500 yesterday. The third mounting screw (#3 in the photo benmcn posted above) stripped its threads while I was cranking the speed up (on mine, it's the one holding the spring that the crank dial rests againt). The screws are 10-24; I ran a 10-24 nut onto the screw, in the hole, and dabbed a little epoxy on it to hold it in place. If that fix fails, I'll look into those press-fit nuts.